268 Using the Operator Panel Menus and Keypad
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
NOTE:
• Values marked by an asterisk (*) are the factory default menu settings.
• Ans Select
Purpose:
To select the default fax receiving mode.
Values:
• Auto Answer Fax
Purpose:
To set the interval at which the printer goes into the fax receive mode after receiving an incoming call. The interval
can be specified within the range of 0 to 255 seconds. The default is 0 second.
• Auto Ans. TEL/FAX
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external telephone receives an
incoming call. The interval can be specified within the range of 0 to 255 seconds. The default is 6 seconds.
• Auto Ans. Ans/FAX
Purpose:
To set the interval at which the printer goes into the fax receive mode after the external answering machine receives
an incoming call. The interval can be specified within the range of 0 to 255 seconds. The default is 21 seconds.
TEL Mode Automatic fax reception is turned off. You can receive a fax by picking
up the handset of the external phone and then pressing the remote
receive code, or by setting OnHook to On (you can hear voice or fax
tones from the remote machine) and then pressing
(Start) button.
For details about Manual Receive, see "Receiving a Fax Manually in
the TEL Mode" on page 235.
FAX Mode* Automatically receives faxes.
TEL/FAX Mode When the printer receives an incoming fax, the external telephone
rings for the time specified in Auto Ans. Tel/Fax, and then the
printer automatically receives a fax. If an incoming call is not a fax,
the printer beeps from the internal speaker indicating that the call is a
telephone call.
Ans/FAX Mode The printer can share a telephone line with an answering machine. In
this mode, the printer will monitor the fax signal and pick up the line if
there are fax tones. If the phone communication in your region is
serial, this mode is not supported.
DRPD Mode Before using the Distinctive Ring Pattern Detection (DRPD) option, a
distinctive ring service must be installed on your telephone line by the
telephone company. After the telephone company has provided a
separate number for faxing with a distinctive ring pattern, configure
the fax setup to monitor for that specific ring pattern.
To Next Page
Loading...
Need help?
General
