Faxing 231
Sending a Delayed Fax
The Delayed Start mode can be used to save scanned documents for transmission at a specified time to take
advantage of lower long distance rates.
1 Load the document(s) face up with top edge in first into the DADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Loading an Original Document" on page 225
2 Press the (Fax) button.
3 Adjust the document resolution to suit your fax needs.
See also:
• "Adjusting the Document Resolution" on page 227
• "Adjusting the Document Contrast" on page 227
4 Select Delayed Start, and then press the button.
5 Select On, and then press the button.
6 Enter the start time using the number pad or select the start time using the or button, and then press the
button.
7 Select Fax to, and then press the button.
8 Select Keypad, and then press the button.
9 Enter the number of the remote machine using the number pad, and then press the button.
You can also use speed or group dial numbers.
See also:
• "Automatic Dialing" on page 238
10 Press the (Start) button to scan data.
Once Delayed Start mode is activated, your printer stores all of the documents to be faxed into its memory and
sends them at the specified time. After faxing in the Delayed Start mode is complete, the data in the memory is
cleared.
NOTE:
• If you turn off and on the printer, the stored documents are sent as soon as the printer is activated.
To Next Page
Loading...
Need help?
General
