Fuji Xerox DocuPrint M355 df - Sending a Fax Manually

Faxing 229
 Sending a Fax Manually
1 Load the document(s) face up with top edge in first into the DADF.
OR
Place a single document face down on the document glass, and close the document cover.
See also:
• "Loading an Original Document" on page 225
2 Press the (Fax) button.
3 Adjust the document resolution to suit your fax needs.
See also:
• "Adjusting the Document Resolution" on page 227
• "Adjusting the Document Contrast" on page 227
4 Select OnHook, and then press the button.
5 Select On, and then press the button.
6 Enter the remote fax machine's fax number using the number pad.
You can also select the recipient by using speed dial number or address book.
See also:
• "Automatic Redialing" on page 230
NOTE:
• You can enter a fax number using the ten key, *, and #.
• Pressing the
(Redial/Pause) button enables you to enter a pause in the fax number.
• Entering "=" in the fax number enables dial tone detection.
• Entering ":" enables you to switch dialing type from dial pulse (DP) to push button (PB).
7 If the document is loaded in the DADF, press the (Start) button.
If the document is not loaded in the DADF, press the (Start) button, press the or button until the
desired setting appears, and then press the button.
NOTE:
• By pressing the (Stop) button, you can cancel the fax job at any time while sending the fax.