404 Maintenance
Moving the Printer
This section describes how to move the printer.
IMPORTANT:
• Two people are required to move the printer.
• To prevent you from dropping the printer and getting backache or injuries, lift the printer by firmly gripping the recessed areas
on both sides of the printer. Never lift the printer by gripping any other areas.
NOTE:
• If the optional 250 sheet feeder has been installed, uninstall the optional 250 sheet feeder before moving the printer. If the
optional 250 sheet feeder is not fixed securely to the printer, it may fall to the ground and cause injuries. For details on how to
uninstall the optional 250 sheet feeder, see "Removing the Optional 250 Sheet Feeder" on page 408.
1 Turn off the printer and disconnect the power cord, interface cable, and any other cables.
IMPORTANT:
• Note that the data in the memory are cleared when the printer is turned off.
2 Remove any paper in the document output tray and slide the document stopper inside the DADF.
3 Remove any paper in the output tray and slide the output tray extension inside the printer.
To Next Page
Loading...
Need help?
General
