Safety Notes 19
Others
Locate this product in a well-ventilated area. Do not obstruct ventilation openings of the product.
Keep the minimum clearance as follows for ventilation and an access to the power plug. Unplug the
product if an abnormal condition is noted.
Do not incline the product at more than 10 degree angle. Otherwise, it may fall over and cause
injuries.
To bundle wires and cables, always use the cable ties and spiral tubes that Fuji Xerox supplies.
Otherwise, it may cause some defects.
To keep this product in a good performance and condition, always use it in the following
environment:
• Temperature: 10 - 32 °C
• Humidity: 10 - 85%
When the product is left in a chilly room and the room is rapidly warmed up by heater, dew
condensation may form inside the product and cause a partial deletion on printing.
930 mm
903 mm
400 mm
400 mm
100 mm
600 mm 426 mm 400 mm
600 mm 426 mm 400 mm
430 mm
110 mm
110 mm
503 mm
Right Left Right Left
Front Back Front Back
10° 10°
10° 10°
To Next Page
Loading...
