Faxing 247
Ring Tone Volume Sets the volume of the ring tone, which indicates that an incoming call is a
telephone call through the internal speaker when Ans Select is set to
TEL/FAX Mode.
Line Type You can select the default line type.
• PSTN
• PBX
Dialing Type You can select the dialing type.
• PB
• DP (10PPS)
• DP (20PPS)
Interval Timer You can specify the interval between transmission attempts within the range
of 3 to 255 seconds. The default is 8 seconds.
Number of Redial You can specify the number of redial attempts to make when the destination
fax number is busy, within the range of 0 to 9. If you enter 0, the printer will
not redial.
Redial Interval Your printer can automatically redial a remote fax machine if it was busy.
Intervals from 1–15 minutes can be entered.
Junk Fax Filter You can reject faxes sent from unwanted stations. The system only accepts
faxes from the remote stations registered in the speed dial. This feature is
useful for blocking any unwanted faxes.
Select Off to turn the feature off. Anybody can send you a fax.
Select On to turn the feature on.
Remote Receive You can receive a fax by pressing the remote receive code on the external
telephone after picking up the handset of the telephone.
Remote Rcv Tone You can specify the tone when Remote Receive is set to
On.
Send Header Prints the sender’s information on the header of faxes.
Select Off to turn this feature off.
Select On to turn this feature on.
Note that if United States is selected for the setting of Region, this option
does not appear on the menu. The setting is fixed to On and cannot be
changed.
For information on the region setting, see "Setting Your Region" on page 222.
Company Name Specifies the sender’s name to be printed on the header of faxes.
Your Fax Number Specifies the fax number of the printer, which will be printed on the header of
faxes. This feature is available when you set Send Header to On. The
number specified in Your Fax Number is used in the printer ID.
Fax Cover Page You can set whether to attach a cover page to faxes when sending faxes.
DRPD Pattern Before using the Distinctive Ring Pattern Detection (DRPD) option, distinctive
ring service must be installed on your telephone line by the telephone
company. After the telephone company has provided a separate number for
faxing with a distinctive ring pattern, configure the fax setup to monitor for that
specific ring pattern.
2-Sided Print You can set whether to make duplex print when you print faxes.
Select Off to print faxes on one side of a sheet of paper.
Select On to print faxes on both sides of a sheet of paper.
Sent Fax Fwd You can set your printer to forward incoming faxes to another fax number.
When a fax arrives at your printer, it is stored in the memory. Then, the printer
dials the fax number that you have specified and sends the fax.
Select Off not to forward incoming faxes.
Select Forward to forward incoming faxes without printing. If an error occurs
during forwarding a received fax, the printer prints the fax.
Select Print & Forward to forward and print incoming faxes.
Fwd. Settings Num You enter the fax number of the destination to which incoming faxes will be
forwarded.
Prefix Dial You can specify whether or not to set a prefix dial number.
Option Description
To Next Page
Loading...
Need help?
General
