62 Upgrade and Maintenance Manual TX140 S1
Basic hardware procedures
I This step is only required when upgrading or replacing non-hot plug
components.
Ê Inform the system administrator that the server will be shut down and put
offline.
Ê Terminate all applications.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section "Verifying and
configuring the backup software solution" on page 96.
Ê In case of Multipath I/O environments, please refer to section "Note on
server maintenance in a Multipath I/O environment" on page 97.
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section "Removing backup and optical disk media" on
page 96.
Figure 8: Power button on the front panel
Ê Shut down the server.
I If the system is running an ACPI-compliant operating system,
pressing the On / Off button will perform a graceful shutdown.
Ê Switch on the ID indicator on the front and rear connector panels of the
server as described in section "Locating the defective server" on page 54.
To Next Page
Loading...
Need help?
General