GE Brivo OEC 715 - Page 122

Brivo OEC 715/785/865/865 Mobile C-Arm X-Ray Product Service Manual
2-68
There are two connectors in GigE camera. One is industrial standard RJ-45 connector for GigE Vision
Protocol on Gigabit Ethernet, IP: 192.168.42.239. The other is HDB15 female connector which provides
power, RS422 and GPIO as following Table:
Pin
Name
Description
1
RSV
Reserved
2
LIH
Input, 12V logic Last image hold
3
TXD485+
Output, RS422 positive terminal of differential TXD signal
4
RXD485-
Input, RS22 negative terminal of differential RXD signal
5
GND
GND
6
RSV
Reserved
7
GND
GND
8
TXD485-
Output, RS422 negative terminal of differential TXD signal
9
RXD485+
Input, RS422 positive terminal of differential RXD signal
10
VCC
+12V supply voltage
11
GND
GND
12
RSV
Reserved
13
RSV
Reserved
14
FrameSync
Output, 12V logic Frame synchronization
15
GND
GND
Lens
GigE Camera AM1565 uses Computar M1614-MP lens. This lens has 16mm focal lens, manual iris F1.4-F16
and manual focus.
Computar M1614 Lens
GigE Camera AM1565 uses an interface flange for mounting itself into image intensifier. This interface flange
is independent part from lens. This interface flange provide three holes and these holes accommodate
errors of at least 2 mm for positioning the image center.
GigE Camera AM1565B use 3D 500025 lens. This lens has 16mm focal lens, manual iris F1.4-F16 and manual
focus.