Software
5-13
• Enable or disable Display Mark: it is used to assist beam alignment calibration. Make sure it is set
back to the default setting “Disable” after beam alignment.
• Enable or disable Shading: it is used to assist to judge shading correction calibration result. Make
sure it is set back to the default setting “enable” after judging shading correction calibration.
• Black/White Margin: This adjustment shall be made very carefully only when necessary, as it may
affect the overall image quality. Pressing up or down arrow allows you to adjust image margin
from 0 to 10000. Increasing White Margin value may decrease the overall contrast and
brightness, and increasing Black Margin value may decrease the overall contrast and increase
the overall brightness.
5.2.6. Maintenance
Export/Import System Setup:
Export/Import configuration file set in user Administration interface by USB disk.
Export/Import Administration Config:
Export/Import configuration file set in service tool (Administration) interface by USB disk.
Recommend export both files before upgrading system Operation System and Application software and
import after upgrading.
Backup/Restore Database:
Backup/Restore Database for/from database pool.
To Next Page
Loading...
