GE Brivo OEC 715 - Introduction; Manual Organization and Use; Objective; Qualifications

Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
2
1.1. Introduction
1.1.1. Objective
Provide Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product service documentation that is consistently
organized, easy to access and is designed to aggressively expedite fault isolation and decrease product
down-time.
1.1.2. Scope
This manual’s contents document the necessary information for service.
1.1.3. Service Philosophy
Brivo OEC 715/785/865 Mobile C-Arm X-Ray Products use precision components and utilize complex
manufacturing techniques. Component-level repairs that maintain compliance with these requirements
are sometimes not possible in the field. The system is therefore designed to be field serviceable at the
modular or Field Replaceable Unit (FRU) level.
1.1.4. Qualifications
Reading this manual does not qualify an untrained person to service the equipment. This publication
assumes the reader is a skilled and fully qualified electronic technician who has experience servicing
medical imaging systems. Factory trained service personnel will benefit the most from this material.
1.1.5. Unauthorized Modifications
GE HUALUN Medical Systems, Inc. certifies that when assembled according to the manufacturer's
instructions, this equipment meets applicable international standards. Unauthorized modifications to the
equipment may impact adherence to these standards and make the equipment unsafe to operate.
The owner is responsible for verifying continued compliance with all applicable regulations and
standards. Consult local, state, federal and/or international agencies regarding specific requirements
and regulations applicable to the use of this type of medical electronic equipment.
1.1.6. Manual Organization and Use
The information documented here has been analyzed and divided into several sections. This manual
contains the following types of information:
• Introduction and Safety-Information of the system and safety.
• System Overview-General description of the system and subsystem. The subsystems have been
analyzed and divided into functional sections. Each functional section contains major assembly
and control locations, theory, functional tests and other information relevant at the subsystem
level.