EasyManuals Logo

GE Brivo OEC 715 Service Manual

GE Brivo OEC 715
551 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #449 background imageLoading...
Page #449 background image
Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
7-42
7.3.10. Parts in Computer and Peripheral
Perform the procedures below to replace the parts of computer.
1. Power off the system and disconnect Workstation’s AC plug
from the AC receptacle.
2. Remove the rear cover, side covers and front cover of the
Workstation.
3. Unplug the cables from the computer. Loosen the screws of
the computer cover. Lift up and remove the cover.
4. Replace the FRU parts (such as the hard disk, display card, Memory Bank, mother board, image
grabber card and Chassis Power) in the computer.
After the display card is replaced, if the software version is 011601 or higher version, it
is required to reinstall the workstation software (OS and Application Software) refer to
section 5.3.1

Table of Contents

Other manuals for GE Brivo OEC 715

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE Brivo OEC 715 and is the answer not in the manual?

GE Brivo OEC 715 Specifications

General IconGeneral
BrandGE
ModelBrivo OEC 715
CategoryMedical Equipment
LanguageEnglish

Related product manuals