GE Brivo OEC 715 - DICOM Setup and Check

Installation
3-25
3.5.6. DICOM Setup and Check
You can choose the verification items from DICOM Worklist server, storage server and
printer server, according to the customer’s network situation and equipment.
Feature for DICOM, available DICOM features are displayed in Product config/Software
Option List, in this section just setup and check the option purchased by customer:
OptionBasicDicom (Contains: DicomWorklist/DicomStorage&Commitment/DicomPrint)
OptionDicomQ&R, OptionDicomMpps.
1. Plug the network cable into the
network connector socket on the
back of Workstation.
2. Press Setup key in
application interface to invoke
the setup interface.
3. Network & DICOM setup:
Click “Network & DICOM” Tab to:
 Input Local AE Title:
The default AE Title is “Brivo
OEC”. You can change it
according to the DICOM service’s
requirement.
 Input Station Name
 Configure system IP:
Click “Config…”button and fill in
the network information.
 Refer to 3.7.10 to perform
Wireless network setup and
verify.
 Verify Network Connection:
Input “Target IP” then click “Ping”
can verify if the Network
configuration is successful or
not.
Configure screen of Local Network