Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
3-66
7. Remove the WiFi power switch baffle and install the WiFi adapter power switch in Workstation cabinet back
plate. Connect the power switch cable to power switch in any Brown/Blue sequence.
8. Reconnect cables of system interface board. Pull back Workstation cabinet and fasten the secure screws.
9. Get an extra laptop/computer and disconnect all wireless/wire connections in extra laptop/computer.
10. Connect Ethernet cable between WiFi adapter and extra laptop/computer.
11. Set extra laptop/computer’s Ethernet port to Obtain an IP address automatically (DHCP mode).
12. Power on the system, and then power on the WiFi adapter.
13. Open Internet browser in extra laptop/computer and input http://www.mywifiext.net/welcome.htm
.
14. On the setup page in the current browser select the preferred language and country/region for the system.
Follow below screen shots as reference.
Wireless power switch baffle
To Next Page
Loading...
