GE Brivo OEC 715 - Page 282

Calibration
4-71
4. If handle is parallel with another, please go to step 4 directly. If handle is not parallel with another,
then Check the mark state of the two screws at the bottom of steering and Loose the two screws and
adjust the handle to be parallel, Retighten them. The torque is 5.8±0.2 Nm. Remark the two screws
position.
5. Check if the steering handle is aligned with wheels or not. If Yes, adjustment is done. If No, find
couplings near the lift column and Check the mark state of the 4 screws on couplings. Loose the 4
screws.
 Unlock brake pedal.
 Adjust steering handle and wheels in align position.