Brivo OEC 715/785/865 Mobile C-Arm X-Ray Product Service Manual
5-32
MCU firmware flash
1. Recommend export the Product configuration
and Software option license file by USB disk, in
administration interface by service authority,
refer to 5.2.2.
2. Shutdown system and remove the Mainframe
back cover and eBox cover.
3. Shorten the boot mode jumper right 2 pins on
the Mainframe Control Board, as shown on
right picture.
4. Plug in the upgrade cable as right picture and
insert USB convertor with upgrade cable to
laptop USB port.
5. Then power on system.
To Next Page
Loading...
