Replacement
7-19
The torque to screw the C-Arm front cover is 2.5Nm. The torque to screw the rear cover is
5.8Nm.
Workstation Covers
Remove Workstation covers in the following sequence:
1. Rear Cover
2. Left and Right lower side covers
3. Front Cover
4. Left and right upper side covers
Follow steps below to remove the Workstation covers:
1. Loosen the 4 screws of the rear cover. Remove the rear cover.
2. Remove the 2 screws on each lower side cover. Remove lower cover on each side.
To Next Page
Loading...
