-
2. To view the Forwarding Database Size, Number of Static Entries and Number of
Dynamic Entries, click Read Database Info.
3. To set the Aging Time, enter the number of seconds in the text box and click the Set
button.
Filtering Entries tab
The Filtering Database configuration pages are used to view, add or delete entries from the
Filtering Database. This feature is available only for the administrator. This Filtering
Database is mainly used during the testing to verify the PRP/HSR functionality. To add an
entry in the forwarding database, click the Filtering Entries tab. Configure as follows:
1. Select the Port Number and MAC Address
2. Set the Entry type (Dynamic or Static)
3. Set the cast type (Unicast or Multicast)
4. Set theMGMT and Rate Limit
5. Click the Create button. The new entry appears in the forwarding database.
To delete an entry from the forwarding database, select the entry and click the Delete Entry
button.
Goose Filtering tab
This page configures the source MACs from which GOOSE messages will be allowed or
blocked. The filtering can be configured by either the MAC address range boxes or by
selecting or unselecting the individual MAC addresses in the MAC table. After you have
defined the addresses to be allowed or blocked you need to update the table and apply the
filter:
• Update Table: This updates the MAC table according to the filtering range entered in
the MAC address range boxes.
• Apply Filter: This applies the filtering configuration in the MAC table to the HSR/PRP
board.
5.12 End of session
To finish the session:
1. In the main window, click the Quit button, a new screen appears.
2. If a database backup is required, click Yes, a new screen appears.
3. Click the ... button to browse the path. Enter the name in the text box.
To Next Page
Loading...
