GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-51
Note: When replacing a BEP, the HASP key must be moved to the new BEP. Ensure that the
HASP key is connected to the parallel port. Make sure that the nominal voltage and range
is set correctly in the Technical Support Tab under System Configuration. (This must be
done by an authorized GE representative). Software version 4.1 or above must be
re-installed - see the Software Installation/Upgrade Procedure on page 8 - 113.
Slide the BEP slightly outwards and proceed to reconnect all the cables at the rear of the BEP as
described in the following steps (refer to Figure 8-42 on page 8-51). Make sure that the HASP key
(option plug) is connected to the correct connector (parallel port).
NOTE: For clarification, the numbers appearing in square brackets in the following steps correspond to the
numbers shown in the illustration of the BEP2 Rear Panel in Figure 8-42 on page 8-51.
13.)Connect the VIC VGA OUT (Left) cable (Part No. 2252964) to the VGA OUT socket [1] on the BEP
rear panel.
14.)Connect the VIC VGA IN (Right) cable (Part No. 2252965) to the VIC VGA IN socket [2].
15.)Connect the other end of this cable (Part No. 2252965) (i.e., the end labelled Back End) to the
VIC VGA OUT socket [2a].
16.)Connect the trackball cable (Part No. 2252978) to the trackball socket [4].
17.)Connect the keyboard cable (Part No.2252977) to the keyboard socket [5].
18.)Connect the cable (Part No. 2253009) to the COM 1 socket [6].
19.)Connect the cable (Part No. 2253016) to the HASP and Parallel OUT socket [7].
20.)If available on the system, connect the USB cable (Part No. 2297905) to the USB socket [8].
Figure 8-42 Cable Connections on new BEP Rear Panel
X
COM1
X
HASP and Parallel OUT
USB
Network
Audio IN/OUT
PC2IP IN/OUT
Ext. Keyboard
COM3 & 4 for Modem
(only if option installed)
VGA OUT (to Monitor)
Power to Keyboard Matrix
RGB Video OUT
Plug & Scan, optional
BEP Power
1
3
4
2
6
5
7
8
9
12
11
10a
10b
VIC VGA IN
Trackball
Keyboard
Do not use
Do not use
Audio IN/OUT
13a
13b
16b
16a
14
15
Frame Grabber Cable
Systems with RFT Configuration:
Systems with RFI Configuration:
OR
VIC VGA OUT
2a
To Next Page
Loading...
