GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
8-124 Section 8-8 - Peripherals
7.) Skip the <Elapsed Time> (Figure 8-116) by pressing the Enter button.
8.) Connect the RS-232C cable and the Audio IN and Audio OUT cables between the appropriate
connections on the Vivid 3 rear panel and the Mitsubishi VCR rear panel (refer to Figure 8-107 on
page 8-119).
9.) On the VCR front panel, verify that the Monitor and Audio switches are in the positions shown in
Figure 8-117 below (if necessary, adjust accordingly) - then move the Key Lock switch to the ALL
position to lock all keys.
10.)Perform the VCR Test, as described in the VCR Test on page 4 - 4.
Figure 8-115 RS-232C Menu Settings
Figure 8-116 Elapsed Time Menu
Figure 8-117 Mitsubishi VCR - Switches Settings (Front Panel)
Monitor Mix
Determines what is sent to MONITOR OUT jack.
(Has no effect on AUDIO OUT).
Audio Hi-Fi
Output High Fidelity audio to AUDIO OUT
CH-1/L and CH-2/R
Key Lock ALL All keys locked in position.
Ch1
Mix
Ch2
Monitor Audio
Key Lock
Hi-Fi
Mix
Norm
Part
All
Off
To Next Page
Loading...
