GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
8-140 Section 8-8 - Peripherals
8-8-6-4 HP 6540/3 USB Deskjet Color Printer Installation Procedure
1.) Place the HP6540/3 USB Deskjet Color Printer on the Vivid™ 4 bottom shelf allowing sufficient
room to access the cables at the rear of the printer, or on a stable surface located not far from the
Vivid™ 4 scanner.
2.) Connect one end of the Printer power cable to the Vivid™ 4 rear connectors panel and the other
end (via the transformer [supplied]) to the Low Voltage Power-IN socket on the rear of the printer,
as shown in Figure 8-134 below.
WARNING: To avoid electrical hazards, the HP 6540/3 USB Deskjet Color Printer must be
connected to the AC Supply of the Vivid™ 4 Ultrasound Unit and never directly to the local AC
wall outlet.
3.) Use the USB cable (shipped with the printer) to connect the Vivid™ 4 system to the USB socket on
the HP6540/3 rear panel (see Figure 8-134).
4.) Turn ON power to the system and the printer and boot up the system in User mode.
5.) Wait until the application finishes loading and then press <Alt> +<Tab> simultaneously.
Figure 8-134 HP 6540/3 Deskjet Color Printer- Rear View
To Vivid 4 rear connectors panel
To Power-IN Socket
Transformer
Low Voltage Power-IN Socket
USB Socket
To Next Page
Loading...
