GE HEALTHCARERAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5459672-100, R
EVISION 6 DRAFT (JANUARY 17, 2013) PROPRIETARY SERVICE MANUAL
5-68 Section 5-15 - LINUX - Voluson Maintenance System
8.) Select 3rd Boot Device and then press ENTER.
9.) Select Third Master and then press ENTER. again.
10.)Press the F10
key to Save and Exit.
11.)Confirm the “Save configuration changes and exit setup” message with OK
and ENTER.
12.)Proceed with SectionSection 5-15-5-4-2 on page 5-68.
5-15-5-4-2 New Hard Disk Setup
NOTE: If not already done, change BIOS “Boot Priority Order” as described in Section 5-15-5-4-1 on page 5-65.
1.) Wait for automatic boot into the “Voluson Maintenance System”.
Figure 5-47 3rd Boot Device
To Next Page
Loading...
