GE HEALTHCARERAFT VOLUSON® P8 / VOLUSON® P6
DIRECTION 5459672-100, R
EVISION 6 DRAFT (JANUARY 17, 2013) PROPRIETARY SERVICE MANUAL
5-70 Section 5-15 - LINUX - Voluson Maintenance System
Please wait until the final window (Figure 5-50 below) appears and then press ENTER.
6.) Remove the System DVD from the DVD/CD+R/RW Drive.
In the displayed menus select [Exit] -> [Exit/Reboot].
7.) During startup, press the DEL
key immediately, to enter the BIOS Setup.
8.) Using the keyboard set “Boot Device Priority” order back to 1. boot device: Hard Disk:
- BIOS Setup Utility (Congatec Dual-core PC-Motherboard installed):
1st Boot Device [P0-xxx] = HDD = Third Master
2nd Boot Device [xxx DVD-RW] = Primary Master
9.) Exit and Save BIOS Settings: Confirm the “Save configuration changes and exit now?” message
with YES
and ENTER. The system boots with windows.
Figure 5-50 New Harddisk setup OK
Figure 5-51 Exit -> Exit/Reboot
NOTICE
An automated process was developed to check disk, assign an unique computer name and matching
drive letters. The system will reboot at least 2 times!
To Next Page
Loading...
