IP8820/IP8830/IP8840
Installer Guide
D-2
Table D-1 Configuration Parameters
Section
Field Name
Description
network_type
Establishes the use of the wired or, if the WiFi Module is
installed, wireless network.
Valid values are Wired or Wireless
Default is wired.
network_mode
Sets use of DHCP or static, manual, addressing. In static
mode, IP parameters are set manually. In DHCP, the IP
Phone requests addresses from the local DHCP server
including Options below:
Option #1 :Subnet Mask
Option #2: Time offset in seconds of the local time zone
from GMT.
Option #3 :Default gateway (router) IP address
Option #6 :DNS server IP address
Option #42 :SNTP server IP address
Option #50 :IP address of the phone
Option #66 :TFTP server name
Option #150 :TFTP server IP address, has priority over
Option #66 when set
Option #160 :HTTPS URL for provisioning, has priority over
Option #66 and #150
Valid values are static and dhcp.
Default is dhcp.
ipAddress
The phone’s IP address
Valid value is an IP address.
Default is “192.168.1.1”.
defaultGateway
The phone’s default gateway
Valid value is an IP address.
Default is “192.168.1.254”.
subnetMask
The phone’s subnet-mask
Default is “255.255.255.0”.
dns1_address IP address of the primary DNS server used to resolve names
to IP addresses.
Valid value is an IP address.
Default is “0.0.0.0”.
dns2_address Optional IP address for a secondary DNS server; used if the
primary DNS server is unavailable.
Valid value is an IP address.
Default is “0.0.0.0”.
tftp_server_address Defines the IP address or URL of a TFTP provisioning
server.
The valid value is an IP address or FQDN up to 60
characters.
The default is blank.
tos Sets Type of Service (ToS) value for SIP packets.
Valid values are 00 to FF (Hex).
Default is 0.
LAN
pc_802_priority Establishes the IEEE 802.1 priority for Ethernet frames at the
PC port of the IP Phone.
Valid values are 0 to 7.
Default is 3.
To Next Page
Loading...