Genban IP8820 - Page 139

IP8820/IP8830/IP8840
Installer Guide
D-13
Section
Field Name
Description
dial_mode
Sets the default dial mode.
Valid values are number (digits), IP address or URL.
The default is number.
pause_timer
Specifies the pause timer, in seconds, for the dial plan.
Valid values are 1 to 30.
The default is 3.
inter_digit_timer
Sets the time delay before dialed digits are sent for normal
dialing, in seconds.
Valid values are 1 to 30.
The default is 6.
dialplan
Specifies the dial plan type.
Valid values are digitmap or routing.
The default is routing.
digitmap
Defines a digit map string for the dial plan,
The valid value is a maximum 750-character string.
Default is “x.T|x+#”.
digitmap_tone
Defines the digit map string to deliver second dial tone for a
dial plan.
The valid value is a maximum 750-character string.
Default is blank.
digitmap_emergency
Defines the emergency call number, see section 4.7
Valid value is a string up to 750 characters.
The default is blank.
DIAL
digitmap_process
Defines the digit map process for a dial plan.
Valid values are:
• num: the digitmap string, maximum 7502-characters.
• trunc: number of digits to strip, 0 to 30.
• prefix: digits to insert in front of the number, maximum 32
digits.
• post: digits to insert at the end of the number, maximum
32 digits.
The default is blank.
PROG
add
prog
Specifies the flexible button number being assigned.
Valid values are
• IP8820 — 2 to 12 or 2 to 36 w/Expansion Modules
• IP8830 — 2 to 24 or 2 to 48 w/ Expansion Modules
• IP8840 — 2 to 10 or 2 to 34 w/ Expansion Modules
The default is blank.