86 / 116
S1002.PRO_mz12PRO_Teil2_V1sh
Fail safe in combination with channel mapping
To make sure that mapped servos react in the same way even in a
malfunction, that is, RC components that are controlled by common
control channel (INPUT CH), the corresponding settings of the INPUT
CH determine the behaviour of mapped components.
If, for example, the servo connections 6, 7 and 8 of the 8-channel
receiver GR-16 are mapped to one another by assigning the same
control channel "04" to the OUTPUT CH (servo connections of the
receiver) 06, 07 and 08 as INPUT CH, independently of the individual
settings of the respective OUTPUT CH, of the INPUT CH 04, the fail-
safe behaviour of these three RC components connected to the con-
trol channel 4 is determined. This is also true when INPUT CH 01 is
used for mapping. In this case, servo connection 04 reacts according
to the fail safe settings of CH 01.
The reaction time or delay set in the "DELAY" line contrastingly
applies uniformly to all channels set to "FAI(L) SAFE".
RX FAIL SAFE V6.37
INPUT CH: 04
MODE : HOLD
F.S.POS. : 1770µsec
DELAY : 0.75sec
OUTPUT CH: 08
POSITION : 1670µsec
FAIL SAFE ALL: NO
RX FAIL SAFE V6.37
INPUT CH: 01
MODE : FAI-SAFE
F.S.POS. : 1500µsec
DELAY : 0.75sec
OUTPUT CH: 04
POSITION : 1500µsec
FAIL SAFE ALL: NO
RX FAIL SAFE V6.37
INPUT CH: 04
MODE : OFF
F.S.POS. : 1670µsec
DELAY : 0.75sec
OUTPUT CH: 06
POSITION : 1670µsec
FAIL SAFE ALL: NO
RX FAIL SAFE V6.37
INPUT CH: 04
MODE : OFF
F.S.POS. : 1230µsec
DELAY : 0.75sec
OUTPUT CH: 07
POSITION : 1670µsec
FAIL SAFE ALL: NO
RX FAIL SAFE V6.37
INPUT CH: 04
MODE : FAI-SAFE
F.S.POS. : 1500µsec
DELAY : 0.75sec
OUTPUT CH: 04
POSITION : 1500µsec
FAIL SAFE ALL: NO
To Next Page
Loading...
Need help?
General