H3C S3100 Series

1-8
Follow these steps to configure errored frame event detection:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the errored frame
event detection interval
oam errored-frame period
period-value
Optional
1 second by default
Configure the errored frame
event triggering threshold
oam errored-frame threshold
threshold-value
Optional
1 by default
Configuring Errored Frame Period Event Detection
An errored frame period event occurs if the number of frame errors in specific number of received
frames exceeds the predefined threshold.
Follow these steps to configure errored frame period event detection:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the errored frame
period event detection
period
oam errored-frame-period period
period-value
Optional
1000 milliseconds by default
Configure the errored frame
period event triggering
threshold
oam errored-frame-period threshold
threshold-value
Optional
1 by default
Configuring Errored Frame Seconds Event Detection
An errored frame seconds event occurs when the number of error frame seconds detected on a port
over a detection interval exceeds the error threshold.
Follow these steps to configure errored frame seconds event detection:
To do… Use the command… Remarks
Enter system view
system-view
—
Configure the errored frame
seconds event detection
interval
oam errored-frame-seconds period
period-value
Optional
60 second by default
Configure the errored frame
seconds event triggering
threshold
oam errored-frame-seconds threshold
threshold-value
Optional
1 by default
Make sure the errored frame seconds triggering threshold is less than the errored frame seconds
detection interval. Otherwise, no errored frame seconds event can be generated.