H3C S3100 Series User Manual

1-6
To do... Use the command... Remarks
Enter Ethernet port view
interface interface-type
interface-number
—
Set the maximum number of
MAC addresses allowed on the
port
port-security max-mac-count
count-value
Required
Not limited by default
Setting the Port Security Mode
Follow these steps to set the port security mode:
To do... Use the command... Remarks
Enter system view
system-view
—
Set the OUI value for user
authentication
port-security oui OUI-value
index index-value
Optional
In userLoginWithOUI mode, a
port supports one 802.1x user
plus one user whose source
MAC address has a specified
OUI value.
Enter Ethernet port view
interface interface-type
interface-number
—
Set the port security mode
port-security port-mode
{ autolearn |
mac-and-userlogin-secure |
mac-and-userlogin-secure-e
xt | mac-authentication |
mac-else-userlogin-secure |
mac-else-userlogin-secure-e
xt | secure | userlogin |
userlogin-secure |
userlogin-secure-ext |
userlogin-secure-or-mac |
userlogin-secure-or-mac-ext
| userlogin-withoui }
Required
By default, a port operates in
noRestriction mode. In this
mode, access to the port is not
restricted.
You can set a port security
mode as needed.
z Before setting the port security mode to autolearn, you need to set the maximum number of MAC
addresses allowed on the port with the port-security max-mac-count command.
z When the port operates in the autoLearn mode, you cannot change the maximum number of MAC
addresses allowed on the port.
z After you set the port security mode to autolearn, you cannot configure any static or blackhole
MAC addresses on the port.
z If the port is in a security mode other than noRestriction, before you can change the port security
mode, you need to restore the port security mode to noRestriction with the undo port-security
port-mode command.

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English