H3C S3100 Series User Manual

1-7
Table 1-7 Display SNMP
Operation Command Description
Display the SNMP information about
the current device
display snmp-agent sys-info
[ contact | location | version ]*
Display SNMP packet statistics
display snmp-agent statistics
Display the engine ID of the current
device
display snmp-agent
{ local-engineid | remote-engineid }
Display group information about the
device
display snmp-agent group
[ group-name ]
Display SNMP user information
display snmp-agent usm-user
[ engineid engineid | username
user-name | group group-name ]
Display Trap list information
display snmp-agent trap-list
Display the currently configured
community name
display snmp-agent community
[ read | write ]
Display the currently configured MIB
view
display snmp-agent mib-view
[ exclude | include | viewname
view-name ]
Available in any
view.
SNMP Configuration Examples
SNMP Configuration Examples
Network requirements
z An NMS and Switch A (SNMP agent) are connected through the Ethernet. The IP address of the
NMS is 10.10.10.1 and that of the VLAN interface on Switch A is 10.10.10.2.
z Perform the following configuration on Switch A: setting the community name and access
permission, administrator ID, contact and switch location, and enabling the switch to sent trap
messages.
Thus, the NMS is able to access Switch A and receive the trap messages sent by Switch A.
Network diagram
Figure 1-2 Network diagram for SNMP configuration
Network procedure
# Enable SNMP agent, and set the SNMPv1 and SNMPv2c community names.
<Sysname> system-view
[Sysname] snmp-agent

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English