H3C S3100 Series

4-2
Operation Command Description
Set the length of the isolation
after an attack is detected
system-guard
timer-interval isolate-timer
Optional
By default, the length of the
isolation after an attack is detected
is 10 minutes.
Displaying and Maintaining System-Guard
After the above configuration, execute the display command in any view to display the running status of
the system-guard feature, and to verify the configuration.
Table 4-2 Display and maintain system-guard
Operation Command
Display the record of detected attacks
display system-guard attack-record
Display the state of the system-guard feature
display system-guard state