H3C S3100 Series User Manual

1-5
z You cannot enable one-to-one VLAN mapping on a link aggregation group member port.
z When you configure a global one-to-one VLAN mapping rule and then enable one-to-one VLAN
mapping on a port, selective QinQ is automatically enabled on the port.
Configuring a Port-Level One-to-One VLAN Mapping Rule
Follow these steps to configure a port-level one-to-one VLAN mapping rule:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
Configure a port-level one-to-one
VLAN mapping rule and enable
one-to-one VLAN mapping on the
port
vlan-mapping vlan
old-vlan-id
remark
new-vlan-id
Required
By default, no port-level one-to-one
VLAN mapping rule is configured,
and one-to-one VLAN mapping is
disabled on all ports.
z In a one-to-one VLAN mapping rule, one original VLAN can be mapped to only one target VLAN,
and vice versa.
z To modify a one-to-one VLAN mapping rule, delete the rule and then define a new one.
z A global one-to-one VLAN mapping rule is mutually exclusive with a port-level one-to-one VLAN
mapping rule.
z To use one-to-one VLAN mapping together with ARP detection properly, enable ARP detection in
both the original VLAN and target VLAN. For more information about ARP detection, see ARP
Configuration.
Configuring Many-to-One VLAN Mapping
Configuring a Many-to-One VLAN Mapping Rule
Follow these steps to configure a global many-to-one VLAN mapping rule
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view of the
downlink port
interface
interface-type
interface-number
—

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English