H3C S3100 Series User Manual

1-14
Configuration procedure
Table 1-9 Apply an ACL to a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Apply an ACL to the port
packet-filter inbound acl-rule
Required
For description on the acl-rule
argument, refer to ACL
Command.
You cannot assign an ACL to a member port of a port group.
Configuration example
# Apply ACL 2000 to Ethernet 1/0/1 to filter the inbound packets.
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] packet-filter inbound ip-group 2000
Displaying ACL Configuration
After the above configuration, you can execute the display commands in any view to view the ACL
running information and verify the configuration.
Table 1-10 Display ACL configuration
Operation Command Description
Display a configured ACL or
all the ACLs
display acl { all | acl-number }
Display a time range or all
the time ranges
display time-range { all | time-name }
Display the information
about packet filtering
display packet-filter { global | interface
interface-type interface-number | port-group
[ group-id ] | unitid unit-id | vlan [ vlan-id ] }
Display the information
about remaining ACL
resources
display acl remaining entry
Display the IPv6 ACL
template configuration
information
display ipv6-acl-template
In any view.

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English