To Next Page

To Previous Page

1-49

[Sysname-mst-region] region-name example

[Sysname-mst-region] instance 1 vlan 10

[Sysname-mst-region] instance 3 vlan 30

[Sysname-mst-region] instance 4 vlan 40

[Sysname-mst-region] revision-level 0

# Activate the settings of the MST region manually.

[Sysname-mst-region] active region-configuration

VLAN-VPN Tunnel Configuration Example

Network requirements

z Switch C and Switch D are the access devices for the service provider network.

z S3100-SI switches operate as the access devices of the customer networks, that is, Switch A and

Switch B in the network diagram.

z Switch C and Switch D are connected to each other through the configured trunk ports of the

switches. The VLAN-VPN tunnel function is enabled in system view, thus implementing

transparent transmission between the customer networks and the service provider network.

Network diagram

Figure 1-11 Network diagram for VLAN-VPN tunnel configuration

Eth 1/0/1

Switch A

Switch D

Switch C

Switch B

Eth 1/0/1

GE 1/0/2

GE 1/0/1

GE 1/0/2

GE 1/0/1

Configuration procedure

1) Configure Switch A

# Enable MSTP.

<Sysname> system-view

[Sysname] stp enable

# Add Ethernet 1/0/1 to VLAN 10.

[Sysname] vlan 10

[Sysname-Vlan10] port Ethernet 1/0/1

2) Configure Switch B

# Enable MSTP.

<Sysname> system-view

[Sysname] stp enable

H3C S3100 Series User Manual

Other manuals for H3C S3100 Series