6-2
Configuring multicast source port suppression in Ethernet port view
Table 6-3 Configure multicast source port suppression in Ethernet port view
Operation Command Remarks
Enter system view
system
-
view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
Configure multicast source port
suppression
multicast-source-deny
Optional
Multicast source port suppression
is disabled by default.
Configuring a Multicast MAC Address Entry
In Layer 2 multicast, the system can add multicast forwarding entries dynamically through a Layer 2
multicast protocol. Alternatively, you can statically bind a port to a multicast MAC address entry by
configuring a multicast MAC address entry manually.
Generally, when receiving a multicast packet for a multicast group not yet registered on the switch, the
switch will flood the packet within the VLAN to which the port belongs. You can configure a static
multicast MAC address entry to avoid this.
Table 6-4 Configure a multicast MAC address entry in system view
Operation Command Remarks
Enter system view
system-view
—
Create a multicast MAC address
entry
mac-address multicast
mac-address
interface
interface-list
vlan
vlan-id
Required
The mac-address argument must
be a multicast MAC address.
Table 6-5 Configure a multicast MAC address entry in Ethernet port view
Operation Command Remarks
Enter system view
system
-
view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
Create a multicast MAC address
entry.
mac
-
address
multicast
mac-address
vlan
vlan-id
Required
The mac-address argument must
be a multicast MAC address.
To Next Page
Loading...
Need help?
General