4-1
4 Device Management
Introduction to Device Management
Device Management includes the following:
z Reboot the Ethernet switch
z Configure real-time monitoring of the running status of the system
z Specify the APP to be used at the next reboot
z Update the Boot ROM
z Identifying and Diagnosing Pluggable Transceivers
Device Management Configuration
Device Management Configuration Tasks
Table 4-1 Device management configuration tasks
Task Remarks
Rebooting the Ethernet Switch Optional
Scheduling a Reboot on the Switch Optional
Configuring Real-time Monitoring of the Running Status of the System Optional
Specifying the APP to be Used at Reboot Optional
Upgrading the Boot ROM Optional
Identifying and Diagnosing Pluggable Transceivers Optional
Rebooting the Ethernet Switch
You can perform the following operation in user view when the switch is faulty or needs to be rebooted.
Before rebooting, the system checks whether there is any configuration change. If yes, it prompts
whether or not to proceed. This prevents the system from losing the configurations in case of shutting
down the system without saving the configurations
Table 4-2 Reboot the Ethernet switch
Operation Command Description
Reboot the Ethernet switch
reboot
[
unit
unit-id ] Available in user view
To Next Page
Loading...
Need help?
General