H3C S3100 Series User Manual

2-16
Configuring RADIUS Accounting Servers
Table 2-14 Configure RADIUS accounting servers
Operation Command Remarks
Enter system view
system-view
—
Create a RADIUS scheme
and enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS scheme
named "system" has already been
created in the system.
Set the IP address and port
number of the primary
RADIUS accounting server
primary accounting
{ ip-address | ipv6
ipv6-address }
[ port-number ] [ key string ]
Required
By default, the IP address and UDP
port number of the primary
accounting server are 0.0.0.0 and
1813 for a newly created RADIUS
scheme.
Set the IP address and port
number of the secondary
RADIUS accounting server
secondary accounting
{ ip-address | ipv6
ipv6-address }
[ port-number ] [ key string ]
Optional
By default, the IP address and UDP
port number of the secondary
accounting server are 0.0.0.0 and
1813 for a newly created RADIUS
scheme.
Enable stop-accounting
request buffering
stop-accounting-buffer
enable
Optional
By default, stop-accounting
request buffering is enabled.
Set the maximum number of
transmission attempts of a
buffered stop-accounting
request.
retry stop-accounting
retry-times
Optional
By default, the system tries at most
500 times to transmit a buffered
stop-accounting request.
Set the maximum allowed
number of continuous
real-time accounting failures
retry realtime-accounting
retry-times
Optional
By default, the maximum allowed
number of continuous real-time
accounting failures is five. If five
continuous failures occur, the
switch cuts down the user
connection.

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English