H3C S3100 Series User Manual

2-4
To do… Use the command… Remarks
Enter system view
system-view
—
Enter VLAN view
vlan
vlan-id
Required
If the specified VLAN does not exist, this
command be created first creates the VLAN
before entering its view.
Add an Access port to the
current VLAN
port
interface-list
Required
By default, system will add all ports to VLAN 1.
Follow these steps to configure the Access-port-based VLAN in Ethernet port view:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
Configure the port link type as
Access
port link-type access
Optional
The link type of a port is Access by
default.
Add the current Access port to a
specified VLAN
port access vlan
vlan-id
Optional
By default, all Access ports belong
to VLAN 1.
To add an Access port to a VLAN, make sure the VLAN already exists.
Configuring a Hybrid-Port-Based VLAN
A Hybrid port may belong to multiple VLANs, and this configuration can only be performed in Ethernet
port view.
Follow these steps to configure the Hybrid-port-based VLAN:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
Configure the port link type as
Hybrid
port link-type hybrid
Required
Allow the specified VLANs to pass
through the current Hybrid port
port hybrid vlan
vlan-id-list
{
tagged
|
untagged
}
Required
By default, all Hybrid ports only
allow packets of VLAN 1 to pass.
Configure the default VLAN of the
Hybrid port
port hybrid pvid vlan
vlan-id
Optional
VLAN 1 is the default by default

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English