H3C S3100 Series

1-3
Task Remarks
Setting PoE Management Mode and PoE Priority of a Port Optional
Setting the PoE Mode on a Port Optional
Configuring the PD Compatibility Detection Function Optional
Configuring PoE Over-Temperature Protection on the Switch Optional
Upgrading the PSE Processing Software Online Optional
Displaying PoE Configuration Optional
Enabling the PoE Feature on a Port
Table 1-3 Enable the PoE feature on a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type interface-number —
Enable the PoE feature on a port
poe enable
Required
z By default, the PoE function on a port is enabled by the default configuration file config.def when
the device is delivered.
z If you delete the default configuration file without specifying another one, the PoE function on a port
will be disabled after you restart the device.
Setting the Maximum Output Power on a Port
The maximum power that can be supplied by each Ethernet electrical port of a PoE-enabled S3100
switch to its PD is 15,400 mW. In practice, you can set the maximum power on a port depending on the
actual power of the PD, in the range of 100 to 15,400 mW and in the granularity of 1 mW.
Table 1-4 Set the maximum output power on a port
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
Set the maximum output power on
the port
poe max-power
max-power
Required
15,400 mW by default.