EasyManuals Logo

H3C S3100 Series User Manual

H3C S3100 Series
1057 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #299 background imageLoading...
Page #299 background image
2-12
Operation Command Remarks
Configure specified port(s) as
static member port(s) of a multicast
group in the VLAN
multicast static-group
group-address
interface
interface-list
Required
By default, no port is configured as
a static multicast group member
port.
Configuring a Static Router Port
In a network where the topology is unlikely to change, you can configure a port on the switch as a static
router port, so that the switch has a static connection to a multicast router and receives IGMP messages
from that router.
In Ethernet port view
Table 2-14 Configure a static router port in Ethernet port view
Operation Command Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type
interface-number
—
Configure the current port as a
static router port
multicast static-router-port vlan
vlan-id
Required
By default, no static router port is
configured.
In VLAN view
Table 2-15 Configure a static router port in VLAN view
Operation Command Remarks
Enter system view
system-view
—
Enter VLAN view
vlan
vlan-id
—
Configure a specified port as a
static router port
multicast static-router-port
interface-type interface-number
Required
By default, no static router port is
configured.
Configuring a Port as a Simulated Group Member
Generally, hosts running IGMP respond to the IGMP query messages of the multicast switch. If hosts
fail to respond for some reason, the multicast switch may consider that there is no member of the
multicast group on the local subnet and remove the corresponding path.
To avoid this from happening, you can configure a port of the VLAN of the switch as a multicast group
member. When the port receives IGMP query messages, the multicast switch will respond. As a result,
the port of the VLAN can continue to receive multicast traffic.
Through this configuration, the following functions can be implemented:
z When an Ethernet port is configured as a simulated member host, the switch sends an IGMP report
through this port. Meanwhile, the switch sends the same IGMP report to itself and establishes a
corresponding IGMP entry based on this report.

Table of Contents

Other manuals for H3C S3100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S3100 Series and is the answer not in the manual?

H3C S3100 Series Specifications

General IconGeneral
BrandH3C
ModelS3100 Series
CategorySwitch
LanguageEnglish

Related product manuals