1-3
Operation Command Remarks
Display the routes that match a
specified basic access control list
(ACL)
display ip routing-table acl
acl-number [ verbose ]
Display the routing table in a tree
structure
display ip routing-table radix
Display the statistics on the routing
table
display ip routing-table statistics
Clear statistics about a routing
table
reset ip routing-table statistics
protocol { all | protocol }
Use the reset
command in user view
Delete all static routes
delete static-routes all
Use the delete
command in system
view.
Troubleshooting a Static Route
Symptom: Both the physical status and the link layer protocol status of an interface are UP, but IP
packets cannot be forwarded on the interface.
Solution: Perform the following procedure.
1) Use the display ip routing-table protocol static command to view whether the corresponding
static route is correctly configured.
2) Use the display ip routing-table command to view whether the static route is valid.
To Next Page
Loading...
Need help?
General