H3C S3100 Series

1-11
3) Adopting dynamic LACP aggregation mode
# Enable LACP on Ethernet1/0/1 through Ethernet1/0/3.
<Sysname> system-view
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] lacp enable
[Sysname-Ethernet1/0/1] quit
[Sysname] interface Ethernet1/0/2
[Sysname-Ethernet1/0/2] lacp enable
[Sysname-Ethernet1/0/2] quit
[Sysname] interface Ethernet1/0/3
[Sysname-Ethernet1/0/3] lacp enable
The three LACP-enabled ports can be aggregated into one dynamic aggregation group to implement
load sharing only when they have the same basic configuration (such as rate, duplex mode, and so on).