3-24
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign Ethernet 1/0/1 through Ethernet 1/0/3 to this VLAN, and enable MLD
snooping in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet 1/0/1 to ethernet 1/0/3
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] quit
# Configure Ethernet 1/0/3 to be a static router port.
[SwitchA] interface ethernet 1/0/3
[SwitchA-Ethernet1/0/3] mld-snooping static-router-port vlan 100
[SwitchA-Ethernet1/0/3] quit
4) Configure Switch B
# Enable MLD snooping globally.
<SwitchB> system-view
[SwitchB] mld-snooping
[SwitchB-mld-snooping] quit
# Create VLAN 100, assign Ethernet 1/0/1 and Ethernet 1/0/2 to this VLAN, and enable MLD snooping
in the VLAN.
[SwitchB] vlan 100
[SwitchB-vlan100] port ethernet 1/0/1 ethernet 1/0/2
[SwitchB-vlan100] mld-snooping enable
[SwitchB-vlan100] quit
5) Configure Switch C
# Enable MLD snooping globally.
<SwitchC> system-view
[SwitchC] mld-snooping
[SwitchC-mld-snooping] quit
# Create VLAN 100, assign Ethernet 1/0/1 through Ethernet 1/0/5 to this VLAN, and enable MLD
snooping in the VLAN.
[SwitchC] vlan 100
[SwitchC-vlan100] port ethernet 1/0/1 to ethernet 1/0/5
[SwitchC-vlan100] mld-snooping enable
[SwitchC-vlan100] quit
# Configure Ethernet 1/0/3 and Ethernet 1/0/5 as static member ports for IPv6 multicast group
FF1E::101.
[SwitchC] interface ethernet 1/0/3
[SwitchC-Ethernet1/0/3] mld-snooping static-group ff1e::101 vlan 100
[SwitchC-Ethernet1/0/3] quit
[SwitchC] interface ethernet 1/5
[SwitchC-Ethernet1/0/5] mld-snooping static-group ff1e::101 vlan 100
[SwitchC-Ethernet1/0/5] quit
6) Verify the configuration
# Display the detailed MLD snooping multicast group information in VLAN 100 on Switch A.
[SwitchA] display mld-snooping group vlan 100 verbose
To Next Page
Loading...
Need help?
General