H3C S3100 Series User Manual

2-2
2) If you use a PC to connect to the Console port, launch a terminal emulation utility (such as Terminal
in Windows XP/Windows 2000. The following assumes that you are running Windows XP) and
perform the configuration shown in
Figure 2-2 through Figure 2-4 for the connection to be created.
Normally, both sides (that is, the serial port of the PC and the Console port of the switch) are
configured as those listed in
Table 2-1.
On the Windows 2003 Server operating system, you need to add the HyperTerminal program first, and
then log in to and manage the device as described in this document. On the Windows 2008 Server,
Windows 7, Windows Vista, or some other operating system, you need to obtain a third party terminal
control program first, and follow the user guide or online help of that program to log in to the device.
Figure 2-2 Create a connection
Figure 2-3 Specify the port used to establish the connection

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English