EasyManuals Logo

H3C S3100 Series User Manual

H3C S3100 Series
1057 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
2
Part Features
05-Static Route Operation
z Introduction to static route
z Static route configuration
z Troubleshooting a static route
06-IP Address-IP Performance
Operation
z Configuring an IP address for a switch
z Configuring the TCP attributes for a switch
07-Voice VLAN Operation
Voice VLAN (applicable only to the S3100-EI series)
08-GVRP Operation GARP VLAN registration protocol (GVRP)
09-Port Basic Configuration
Operation
z Configuring port auto-negotiation speed
z Limiting traffic on individual ports
z Enabling flow control on a port
z Duplicating the configuration of a port to other ports
z Configuring loopback detection for Ethernet port(s)
z Enabling loopback test
z Configuring a port group
z Enabling the system to test connected cable
z Configuring the interval to perform statistical analysis on port traffic
z Disabling Up/Down log output on a port
z Configuring storm control on a port
z Setting the port state change delay
10-Link Aggregation Operation
z Link aggregation control protocol (LACP)
z Manual aggregation
z Static aggregation
11-Port Isolation Operation
Port isolation group
12-Port Security-Port Binding
Operation
z Configuring port security
z Configuring port binding (applicable only to the S3100-EI series)
13-DLDP Operation
Device link detection protocol (DLDP) (applicable only to the S3100-EI
series)
14-MAC Address Table
Management Operation
z Manually configuring dynamic, static, and black hole MAC addresses
z Setting the MAC address aging timer
z Setting the maximum number of MAC addresses a port can learn
z Disabling MAC address learning for a VLAN (applicable only to the
S3100-EI series)
z Assigning MAC addresses for Ethernet ports
z Configuring MAC address replication (applicable only to the S3100-EI
series)
15-MSTP Operation
z STP/RSTP/MSTP overview and basic configuration
z Performing mCheck operation
z Guard functions: BPDU Guard, Root Guard, Loop Guard, TC-BPDU
Attack Guard, and BPDU Drop (BPDU Drop is applicable only to the
S3100-EI series)
z Digest snooping
z Rapid transition
z VLAN-VPN tunnel (applicable only to the S3100-SI series)
z MSTP maintenance configuration
z Sending trap messages conforming to 802.1d standard

Table of Contents

Other manuals for H3C S3100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S3100 Series and is the answer not in the manual?

H3C S3100 Series Specifications

General IconGeneral
BrandH3C
ModelS3100 Series
CategorySwitch
LanguageEnglish

Related product manuals