H3C S3100 Series User Manual

2-14
To reduce the risk of being attacked by malicious users against opened socket and enhance switch
security, the S3100 series Ethernet switches provide the following functions, so that a cluster socket is
opened only when it is needed:
z Opening UDP port 40000 (used for cluster) only when the cluster function is implemented,
z Closing UDP port 40000 at the same time when the cluster function is closed.
On member devices, the preceding functions are implemented as follows:
z When you execute the add-member command on the management device to add a candidate
device to a cluster, the candidate device changes to a member device and its UDP port 40000 is
opened at the same time.
z When you execute the auto-build command on the management device to have the system
automatically add candidate devices to a cluster, the candidate devices change to member devices
and their UDP port 40000 is opened at the same time.
z When you execute the administrator-address command on a device, the device's UDP port
40000 is opened at the same time.
z When you execute the delete-member command on the management device to remove a
member device from a cluster, the member device's UDP port 40000 is closed at the same time.
z When you execute the undo build command on the management device to remove a cluster, UDP
port 40000 of all the member devices in the cluster is closed at the same time.
z When you execute the undo administrator-address command on a member device, UDP port
40000 of the member device is closed at the same time.
Enabling NDP globally and on specific ports
Follow these steps to enable NDP globally and on specific ports:
Operation Command Description
Enter system view
system-view
—
Enable NDP globally
ndp enable
Required
In system view
ndp enable interface port-list
Enter
Ethernet port
view
interface interface-type
interface-number
Enable
NDP on
specified
ports
In
Ethernet
port view
Enable NDP
on the port
ndp enable
Required
Use either
approach.
Enabling NTDP globally and on a specific port
Follow these steps to enable NTDP globally and a specific port:
Operation Command Description
Enter system view
system-view
—
Enable NTDP globally
ntdp enable
Required

H3C S3100 Series Specifications

General

Brand	H3C
Model	S3100 Series
Category	Switch
Language	English