1-8
[SwitchA] interface Ethernet 1/0/8
[SwitchA-Ethernet1/0/8] poe enable
[SwitchA-Ethernet1/0/8] poe priority critical
[SwitchA-Ethernet1/0/8] quit
# Set the PoE management mode on the switch to auto (it is the default mode, so this step can be
omitted).
[SwitchA] poe power-management auto
# Enable the PD compatibility detect of the switch to allow the switch to supply power to part of the
devices noncompliant with the 802.3af standard.
[SwitchA] poe legacy enable
To Next Page
Loading...
Need help?
General