1-22
[Sysname-hwping-administrator-dhcp] source-interface Vlan-interface 1
# Configure to make 10 probes per test.
[Sysname-hwping-administrator-dhcp] count 10
# Set the probe timeout time to 5 seconds.
[Sysname-hwping-administrator-dhcp] timeout 5
# Enable the saving of history records and set the maximum number of history records that can be
saved to 10.
[Sysname-hwping-administrator-dhcp] history-record enable
[Sysname-hwping-administrator-dhcp] history-records 10
# Start the test.
[Sysname-hwping-administrator-dhcp] test-enable
# Display test results
[Sysname-hwping-administrator-dhcp] display hwping results administrator dhcp
HWPing entry(admin administrator, tag dhcp) test result:
Send operation times: 10 Receive response times: 10
Min/Max/Average Round Trip Time: 1018/1037/1023
Square-Sum of Round Trip Time: 10465630
Last complete test time: 2000-4-3 9:51:30.9
Extend result:
SD Maximal delay: 0 DS Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0 Operation timeout number: 0
System busy operation number: 0 Connection fail number: 0
Operation sequence errors: 0 Drop operation number: 0
Other operation errors: 0
[Sysname-hwping-administrator-dhcp] display hwping history administrator dhcp
HWPing entry(admin administrator, tag dhcp) history record:
Index Response Status LastRC Time
1 1018 1 0 2000-04-03 09:51:30.9
2 1037 1 0 2000-04-03 09:51:22.9
3 1024 1 0 2000-04-03 09:51:18.9
4 1027 1 0 2000-04-03 09:51:06.8
5 1018 1 0 2000-04-03 09:51:00.8
6 1020 1 0 2000-04-03 09:50:52.8
7 1018 1 0 2000-04-03 09:50:48.8
8 1020 1 0 2000-04-03 09:50:36.8
9 1020 1 0 2000-04-03 09:50:30.8
10 1028 1 0 2000-04-03 09:50:22.8
For detailed output description, see the corresponding command manual.
You can perform an HWPing DHCP test only when no DHCP client is enabled on any interface.
Otherwise, the DHCP Server sends the response to an interface enabled with the DHCP Client rather
than to the source interface, thus resulting in HWPing DHCP test failure.
To Next Page
Loading...
Need help?
General