Drawbar Effects - Vibrato
101
Adjusting the Vibrato and Chorus Modes using a Shortcut
The SKX has a “Shortcut” feature that enables you quickly to access the portion of the VIB/CHS Edit Menu which
contains the settings for Vibrato and Chorus (V-1, V-2, V-3, C-1, C-2, C-3). The following paragraphs will explain how
to do this.
Locate the FAVORITE Button section.
Notice that FAVORITE Buttons 3, 4, 5, 8, 9 and 10 have designations which correspond to the Vibrato Mode
settings. When you are in the VIB/CHR Edit Mode, you can use these FAVORITE Buttons to select the
Vibrato/Chorus Mode that will be added to the ORGAN section when either of the two VIBRATO Touch Tabs
is “ON” (LED lit).
Each Button is clearly marked as to which Mode setting it will control.
TRY THIS:
1. Touch and hold any of the VIBRATO/CHORUS Touch Tabs. After approximately 1 second, the
Information Center Display should now look similar this:
Notice that the legend underneath the word “MODE” is blinking. The specific mode will vary depending on
which Patch is currently selected.
2. If you wish to change the Mode setting, Touch and Hold either of the two VIBRATO Touch Tabs:
HA<O> SKX Owner’s Playing Guide
To Next Page
Loading...
Need help?
General
