Patches & Favorites
163
Ë Editing a Patch
Although you can create entirely new Patches and store them, there may be occasions when a Patch already contains
most of what you need, and only one or two changes (Extra Voice, Reverb amount, etc.) need to be made.
To edit an already existing Patch and re-save it with new settings, do the following:
TRY THIS:
1 From either of the PLAY Modes, use the VALUE Rotary Knob to select the User Patch you want to
change.
2. Make whatever changes to the Patch you wish.
3. After you have finished making your changes, Touch the RECORD Touch Button. The Information
Center Display should look similar to this:
4. Now touch the ENTER Touch Button. The lower line of the Information Center Display will briefly
show:
Recording Patch...
When the above message disappears, the Patch is updated with your new settings.
NOTE: After Patches have been saved, they can then be stored to a USB Flash Drive. This is covered
in the USING THE USB PORT section.
HA<O> SKX Owner’s Playing Guide