Drawbars & Percussion
60
If you followed the instructions on the previous page, you should now see Page 1 of the PERCUSSION Edit Menu.
The number underneath the word “SOFT” should now be blinking.
Percussion Edit Page 1 - Percussion Level
This Advanced Feature allows you to set the overall volume level of the Percussion tones. This will allow you to balance
the amount of "normal" and "soft" Percussion sound (the choices provided by the Touch Tabs) with the sound produced
by the Drawbars. You can set the levels separately for the “SOFT “ and “NORM” (normal) Percussion Touch Tab
settings.
Use the PAGE LEFT and PAGE RIGHT Touch Buttons to select either “SOFT” or “NORM” (Normal). When you have
made your selection:
Turn the VALUE Rotary Control to the right to increase the level.
Turn the VALUE Rotary Control to the left to decrease the level.
Percussion Edit Page 2 - Percussion Decay
From the previous screen, touch the PAGE RIGHT Touch Button until Page 2 of the Percussion Edit Menu displays.
The number underneath the word “SLOW” should now be blinking.
This Advanced Feature allows you to set the overall decay (the rate at which the Percussion tone dies away while a key
is held) of the Percussion tones. You can adjust the “SLOW” and “FAST decay amounts separately so as to customize
the Percussion Decay to your liking.
IMPORTANT NOTE: This Advanced Feature replicates the PERCUSSION CUTOFF control found on the
preamp of a vintage Hammond Organ.
Use the PAGE LEFT and PAGE RIGHT Touch Buttons to select either “SLOW” or “FAST.” When you have made your
selection:
Turn the VALUE Rotary Control to the right to lengthen the Decay.
Turn the VALUE Rotary Control to the left to shorten the Decay.
HA<O> SKX Owner’s Playing Guide
To Next Page
Loading...
Need help?
General
