Set-procedure:
When the user wants to set the area / system he reads the card and presses the - key. Like in all set/unset
procedures the reader demands the PIN-code. If all detectors can be set the reader will indicate the set status of
the THOR system. If all areas have been set the reader will indicate SYSTEM SET.
If one or more detectors are giving a set fault, the list of detectors with problems will be shown as on a normal
THOR intrusion remote keypad and the detectors can be isolated etc. as wanted.
Please note that the door will be closed before the set procedure takes place, meaning that the reader must be
situated outside the secured area.
To Next Page